Wall bracket offering adjustment from wall of 100mm - 210mm (Long bracket). Tested and passed to force of 80MPH wind.
To be used with short wall bracket
Wall bracket (Short) offering adjustment from wall of 50mm - 100mm. Tested and passed to wind force of 80MPH.
Designed to be used at the top of a lowered chimney stack in the loft space allowing to connect Nexus to a Flue liner. The plate will need to be bolted down to the chimney stack with a motar mix placed on top offering a transition adaptor with support. Made in UK
The D5 offers a more aesthetically pleasing flat appearance to the standard ventilated plates, whilst still incorporating an intumescent matrix for maximum safety. This component is finished to a high quality gloss white finish to blend in with a ceiling. Made in UK.
Can be used to stabalise Nexus on the roof.
Designed to allow Nexus twin wall insulated chimney to be supported on roof joists/rafters etc. Supplied with a diameter specific rotational clamp band. Maximum suspended chimney length supported is 9m when supported on a truss or 6m when supported below the truss. Suitible for up to 600mm rafter span. Nexus can be installed with 3m freestanding from the last support as standard. Twist lock system with locking barbs and 50mm band for rapid and robust installation. Manufactured in UK
Can be used to extend free standing height from 2.5m to 3.5m. Must be used on all joints from the last support to achieve this.
To be used to take vertical load of the chimney when supported from a wall. Adjustment 50mm - 150mm. Requires M10 Wall fixings. Support length included.